Frequently Asked Questions - K-FEE Java Square ID2 Mode D'emploi

Frequently asked questions

SAFETY INFORMATION
The appliance only functions correctly
with drink capsules of any brand which are
labelled with the K-fee® – your system logo.
Use of non-original capsules can result in the fol-
lowing risks: health risks, damage to the appliance
and possible loss of warranty claims.
All function buttons flashing rapidly?
The appliance could be overheated or have a fault. Switch the appliance off, remove the
mains plug and allow the appliance to cool down. After this, reinsert the mains plug
again and switch the appliance on. If the error message occurs again, please contact
our service centre.
Drinks not being prepared properly?
Check to ensure that the lever has been pressed down completely. If, despite this, the
error occurs again you should clean the appliance (see instructions p. 20/21: Cleaning
with a cleaning capsule or p.22/23: Cleaning with cleaning fluid) and also descale it
(see instructions p. 24/25).
If the water runs out during drinks output: Interrupt drinks preparation by pressing
any button. Open and close the lever to eject the capsule, remove the water tank,
refill it with fresh water and insert it in the appliance again. Place collecting
container under the spout and rinse the appliance out until water flows out of the
drinks spout.
Drink dispensing is delayed?
The appliance is heating up.
Liquid capacity during drinks preparation is insufficient?
The system could be calcified. Descale the appliance in accordance with the in-
structions on p. 24/25. If the problem continues to occur, please check the cup
filling capacity you have programmed. If required, reset the appliance to the factory
settings (see instructions p.17) and then re-programme your individually required cup
filling capacity (see instructions p. 16).
28