Schlage BE365 Mode D'emploi page 4

b
Unlock (retract bolt).
1. Find User Code A on the
label located on the cover
of these instructions.
2. Enter User Code A
(four digits) into the
keypad.
3. Rotate thumbturn away
from door edge.
Quick Programming Reference
Adding User Codes*
Press
Enter
Programming Code
(six numbers)
Wait for
Keypad
turns
3 Orange Lights +
blue
3 Beeps
* These four numbers must be different from the first four numbers of the programming code.
More Programming, Warranty, and Registration Information
For more programming, warranty, and service information, go to
schlage.com/faqs-keypad, or use a mobile device with the code
below:
Press
Enter new
User Code
(four numbers)
Wait for Wait for
3 Orange Lights + 3 Orange Lights +
3 Beeps 3 Beeps
Did bolt retract?
Yes. Lock is
installed correctly.
Deleting User Codes
Enter same
Enter
new
Programming Code
User Code
(six numbers)
(four numbers)
Success!
Wait for
1 Green Light +
3 Orange Lights +
Long Beep
3 Beeps
Changing the Programming Code*
Enter
Programming
Code
(six numbers)
Wait for
3 Orange Lights +
3 Beeps
* The first four numbers must be different from all of the User Codes currently in the lock.
Register your product at RegisterMySchlage.com, or use a mobile
device with the code below:
No. Lock is not installed
correctly. Remove lock and
reinstall. Pay close attention
to cam position in step 1.
Press Press
Enter unwanted
User Code
(four numbers)
Wait for
Keypad
turns
3 Orange Lights + 3 Orange Lights +
blue
3 Beeps
Press Press Enter New
Programming
(six numbers)
Wait for Wait for
Keypad
turns blue
3 Orange Lights + 3 Orange Lights +
3 Beeps 3 Beeps
Enter same
unwanted
User Code
(four numbers)
Wait for Success!
1 Green Light +
3 Beeps 1 Long Beep
Enter Same New
Programming Code
Code
(six numbers)
Success!
1 Green Light +
Long Beep