Controls & Features - Cub Cadet Challenger 400 Manuel De L'utilisateur

Controls & Features
A
B
C
D
E
F
G
H
I
J
K
L
A Instrument Cluster
B Choke Knob
C Ignition Switch
D Hood Latch
E Steering Wheel
F Accelerator Pedal
G Brake Pedal
H Parking Brake Lever
I Seat Belt Latch
J Seat Belts
K Cargo Bed Latch Lever
Read this operator's manual, safety symbols, and operating instructions on the vehicle before operating.
Compare the illustrations in this manual with your unit to familiarize yourself with the location of various
controls and adjustments. Reference to the right or left hand side of unit is observed from the operating
position. Save this manual for future reference.
IMPORTANT: Refer to the Engine Operator's Manual before operating this vehicle to familiarize yourself with
the engine controls and adjustments.
U
T
S
O O
O O
V
Figure 3-1
L Tailgate Latch
M Bed Tie-Down Ring
N Fuel Tank
O Differential Lock Lever
P Shift Lever
Q 12 Volt Power Outlet
R Handhold
S Auxillary Switch Panel
T Operator Protective Structure (OPS)
U Cup Holders
V Hitch Plate
Instrument Cluster
The instrument cluster is located in the middle of the
dash panel. It contains multiple displays, indicator
lights and mode buttons. It displays Fuel Level,
R
Vehicle Speed (KM/H, MPH), Gear Selection (F, N or R)
and the Odometer reading when the key is turned to
the "ON" position. In addition, the Seat Belt Warning
D
Indicator will flash for 8 seconds to remind the
operator and passenger to fasten their seat belt.
The Low Voltage Indicator will illuminate when your
R
battery reaches 11.6 volts. The other indicator lights
will not illuminate until that function is used.
The Fuel Level is divided into 5 segments and flashes
at the lowest increment. See Figure 3-2.
Q
The MODE button switch changes the display from
distance driven (KM/MILE) to time of use (Hrs.).
P
The KM/MILE button switch changes the display
O
from KM/H to MPH. See Figure 3-2.
J
I
N
Seat Belt Warning
M
L
Hour Meter
The hour meter is located in the instrument cluster.
To display the hour meter, press the mode button
switch to change the display from distance driven to
time of use. It records the elapsed time when the key
is in the Run position. See Figure 3-2.
Choke Knob
The choke knob is located to the right of the ignition
switch on the dash. The choke is used when starting
a cold engine. To set, pull out to engage, push in to
disengage.
Low Voltage Indicator
Parking Brake
High Beam Indicator
Indicator
Indicator
Figure 3-2
3
Gear Position
Indicator
7