Guarantee And Service; Frequently Asked Questions - Philips AVENT SCD510 Mode D'emploi

Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 28).
- Rechargeable and non-rechargeable batteries contain substances that may pollute the
environment. Do not throw away rechargeable and non-rechargeable batteries with the normal
household waste, but hand them in at an official collection point. Always remove rechargeable
and non-rechargeable batteries before you discard and hand in the appliance at an official
collection point. (Fig. 29)

guarantee and service

If you need service or information or if you have a problem, please visit the Philips AVENT website
at www.philips.com/welcome or contact the Philips Consumer Care Centre in your country (you
find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.

Frequently asked questions

This chapter lists the questions most frequently asked about the appliance. If you cannot find the
answer to your question, contact the Consumer Care Centre in your country.
Question
Why don't the power-on
light of the baby unit and
the LINK light of the parent
unit come on when I press
the on/off buttons of the
units?
Why does the LINK light
on the parent unit flash
red?
Why does the battery light
on the baby unit flash red?
Why does the parent unit
beep?
Answer
Perhaps the rechargeable batteries of the parent unit are empty and
the parent unit is not connected to the mains. Insert the small
appliance plug into the parent unit and put the adapter in a wall
socket. Then press the on/off button to establish connection with
the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty
and the baby unit is not connected to the mains. Replace the
non-rechargeable batteries or connect the baby unit to the mains.
Then press the on/off button to establish connection with the
parent unit.
If the LINK light on the parent unit still does not start to flash, use
the reset function to reset the units to their default settings.
The baby unit and the parent unit are out of range of each other.
Move the parent unit closer to the baby unit.
The baby unit may be switched off. Switch on the baby unit.
The non-rechargeable batteries of the baby unit are running low.
Replace the non-rechargeable batteries or connect the baby unit to
the mains (see chapter 'Preparing for use').
If the parent unit beeps while the LINK light flashes red, the
connection with the baby unit is lost. Move the parent unit closer to
the baby unit.
If the parent unit beeps and the battery light flashes red, the
rechargeable batteries of the parent unit are running low. Recharge
the batteries.
EngliSh
13