Power Supply - Breg POLAR CARE WAVE Mode D'emploi

OPERATING INSTRUCTIONS
Setup with Breg Ice Bag Accessories and Water:
Remove four (4) empty Breg Ice Bags from the packaging. Only

use Breg Ice Bags that come with the Polar Care Wave.

Fill the four (4) Breg Ice Bags with water to fill line. Do not over fill.
Freeze Breg Ice Bags in freezer. Dry Breg Ice Bag exterior before

placing in freezer.

Set up and operate unit on a flat surface so the unit does not tip over.
Unlock handle by rotating handle to the front of the unit.

Remove lid and add water to fill line in container.
Place all four (4) Breg Ice Bags into the corners of the container
as shown.

Only use ice and water or four (4) Breg Ice Bags and water with
this unit.

Replace lid and lock by rotating the handle to the upright or back position.
Replace four (4) melted Breg Ice Bags with four (4) frozen Breg Ice Bags every 4-5 hours or as

needed. While using the Breg Ice Bags, cubed ice may also be added to the container up to the
ice fill line to optimize the colder setting.

Power Supply:

Plug power supply into the wall and other end

of cord into lid.
FIRST ADD WATER
SECOND ADD ICE BAGS
11