Ribimex Ribiland PRSC600/200N Manuel D'instructions Et D'utilisation page 27

Before further use or reuse of the product, it should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and
any other conditions that may affect its operation.
Replace damaged, worn out or illegible labels / stickers.
17. Do not abuse the power cable
Never carry the tool by the cable or yank it to disconnect it from the socket.
Keep the cable away from heat, oil and sharp edges.
Inspect tool cable periodically and if damaged have it repaired by an authorized service facility.
18. Use of extension leads
Do NOT use cable reels.
When tool is used with extension cord, ensure that extension cord withstands tool ratings.
If used outdoors, use only extension cords intended for outdoor use. Fully extend the extension cord.
Improper use of extension cords may cause inefficient operation of the log saw which can result in
2
overheating. Be sure the extension cord is no longer than 10m and its section is no less than 1.5mm to
allow sufficient current flow to the motor. Avoid use of free and inadequately insulated connections.
Connections must be made with protected material suitable for outdoor use.
Inspect extension cords periodically and replace, if damaged.
19. Defective switches or other part that is damaged should be properly repaired or replaced by an
authorized service centre. Do not use the product if the switch does not turn it on and off.
20. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
21. Have your product repaired by qualified personnel
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorised service centre is recommended.
This product is in accordance with the relevant safety requirements. Repairs should only be carried
out by qualified persons using original spare parts, otherwise this may result in considerable danger to
the user.
22. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
23. Note: For specific maintenance and safety information about this product, consult the user's
manual provided with it. If it has been lost or misplaced, contact your local retailer for a replacement.
24. Important: The information contained in this instructions manual describes components available
at the time of publication. We reserve the right to make changes without prior notice and without
obligation to make alterations to components previously manufactured.
The procedures described in this manual are intended to help you get the most from your machine as
well as to protect you and others from harm. These procedures are guidelines for safe operation under
most conditions and are not intended to replace any safety rules and/or laws that may be in force in
your country / area.
25. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design.
Residual risks may be reduced when the user carefully follows the "safety instructions" and the use of
the product "in accordance with its intended purpose" as well as all instructions stated in this manual.
Awareness and caution reduce risk of injury and damage.
- Ignoring or omitting to follow the safety precautions may result in injury or damage.
Page 27 of 28