Pump/Charger Connection; Instructions For Use - Abbott FLEXIFLO Companion Mode D'emploi

PUMP/CHARGER CONNECTION

To Separate: When properly seated, pump is held firmly within the charger base.
To separate pump and charger, locate pump release latch on the back of the charger
within the handle cavity. Pull the latch toward the pole clamp knob and slide pump
out of the charger. Grasp pump securely to withdraw it from charger.
To Reconnect: With pump display panel facing outward, slide pump into charger,
using built-in guides for alignment. Slide pump in until it snaps into position, and
verify that it is locked in place. When properly seated, pump case will not protrude
from charger.
Pole Clamp: Pump must be inserted into charger before pole attachment. Pole clamp
mechanism is controlled by a knob on the right side of the charger. Align pole cavity
(located at back of charger) with the pole, turn knob clockwise until the pole is
firmly captured.
NOTE: The Companion
Companion™ ClearStar™ Enteral Pump Charger.

INSTRUCTIONS FOR USE

Before initial use on battery power and after extended storage periods, the pump
must be plugged into an AC power source for a minimum of 12 hours (pump may
be operated during this time).
DANGER: Possible explosion hazard if used in the presence of flammable
anesthetics.
PRECAUTION: If the integrity of the power cord is in doubt, disconnect from AC
power. Return pump for servicing.
1. Confirm proper placement and function of patient's enteral feeding tube
(nasoenteric, jejunostomy, gastrostomy, etc).
2. Attach to or place on an appropriate feeding stand or pole. If a pole is used, be
sure pump is properly seated in charger before clamping to the pole. To ensure
stability of a portable stand, position the pump no higher than 45 inches from
the floor.
Note: If using the Companion Ambulatory Transporter, refer to Directions for Use
included with the Transporter unit.
®
Enteral Pump Charger is not interchangeable with the
13