10. Filling the pool
WARNING: Do not use recovered water (from a well or
river, for example).
Start filling the pool with 1 or 2 cm of water. Spread the liner out
on the bottom and remove any wrinkles by sliding them with the
flat of your hand from the centre of the pool towards the edge, until
they are completely gone.
Once the liner is in place, you can then install the plastic and metal
profiles as well as the connecting plates. Cut off the excess of the
last plastic profile. Install the top rails perpendicular to the bottom
rails and place the connecting plates back on the rails without
fixing them.
You must stay in or nearby the pool until the water level reaches
a height of 20 cm. From within the pool, gently tap the base to
position the pool wall on the ground tracks. At this stage, if the liner
is laid correctly, you can permanently fix the connecting plates with
the fastening screws.
The cut outs in the liner for the installation of the skimmer
and the discharge nozzle must be done before totally filling
the pool with water (see chapter 12 "filtration").
11. Installation of the ledge pieces and
covering plates
The ledge pieces must be assembled in a certain position. The widest edge must be on the outside.
The ledge pieces must be positioned between the posts.
The ends of the ledge pieces are fixed to a connecting plate using screws. You may need to gently move the posts to the left or
right to install the ledge pieces. Do not fully tighten the screws until they are all in place.
Fit the covering plates over the extremities of the ledge pieces and centre them. The narrowest part of the covering plate should
be located on the inside of the pool.
0341
2176
OSMOSE Round
1212 / 1615 / 1618
Rail
8100
Profile
1171 or 1174
Ledge piece
2475
0341
68
2176
Sides
Assembly Guide 880114-rev A
2476