Installing The Liner (To Be Installed Barefoot) - Trigano Jardin OSMOSE RONDE Notice De Montage Et Guide D'utilisation

INSTALL THE GROUND SHEET OR GEOTEXTILE FILM (note: the ground sheet is not included in all kits)
It is important to backfill 8 to 10 cm (mound of fine sand) all around the base of the inside of the pool and, particularly, along the
sides of the pool, and to cover the entire surface of the pool with a 2 cm layer of sand. The sand prevents the liner from sliding
under the metal sheet and protects it from perforation from the protruding parts of the pool structure.
Cover the prepared ground with a geotextile film that goes 10 to 12 cm up the wall. Stick the film to the wall in various places
using double-sided adhesive tape. The geotextile film prevents algae from spreading under the liner.
POOL WALL CUT OUTS
After assembling the wall, make the skimmer and discharge nozzle cut outs using metal cutters. File the edges of the cut outs and
apply rustproofing agent. We advise wearing gloves during this process.

9. Installing the liner (to be installed barefoot)

WARNING: This is a delicate process and must be carried out with utmost caution.
We recommended installing the liner when the outdoor temperature is between 18°C and 25°C. Use the ladder to enter and
exit the pool during installation. Unfold the liner inside the pool and spread it out until it reaches the edges of the pool. The side
where the seams are smooth is the inside of the liner.
After removing 2 or 3 of the upper rails, start to pull the edges of the liner above the wall allowing it
to overhang by 10 to 20 cm. Hold it in place temporarily with clothes pegs or using the rails provided
for this purpose. Do not over-stretch the liner. Use your feet to spread the bottom of the liner out until
it reaches the base of the metal sheet wall. Repeat this on the opposite side and in two other areas.
This will enable you to check that the liner is properly centred. There should not be any large folds
running across it. Continue to lift the liner all around the pool, holding it in place with other clothes
pegs.
Important!
The liner must be lying against the bottom of the pool before water is added.
OSMOSE Round
10 cm
Sides
Sand
Incorrect
Liner
67
2 cm
Correct
Position the joins as best as
possible against the wall
Liner
Assembly Guide 880114-rev A