Assembling The Plastic Profiles On The Posts; Assembling The Bottom Rails - Trigano Jardin OSMOSE RONDE Notice De Montage Et Guide D'utilisation

6. Assembling the plastic profiles on the posts

Before beginning to assemble your pool, assemble the plastic profiles on to the posts.

7. Assembling the bottom rails

If the pool is not installed on a concrete slab, place a concrete plate approximately 30 x 30 x 5 cm in size at each connecting
point of the bottom rails. These plates must be placed in such a way that their surface arrives exactly at ground level.
WARNING: The entire length of the connecting plate must be laid flat over the flat surface. Using a slab that is too short,
or the absence of a slab, could make installation inadequate or cause the swimming pool to collapse.
Before assembling the bottom rails of the swimming pool, place the lining inside the pool enclosure.
OSMOSE Round
1212 / 1615 / 1618
Rail
Sand
2276
Connecting plate
Slab 30 x 30 x 5
cm
65
88034X
Plastic profile
Sides
2377
Vertical post
Pool interior
Pool exterior
Slide the rails into the connecting
plates leaving a space of around
1 cm between the rails at the
centre of the connecting plate.
Assembly Guide 880114-rev A