Installation Of The Pool Wall - Trigano Jardin OSMOSE RONDE Notice De Montage Et Guide D'utilisation

8. Installation of the pool wall

WARNING: An incorrectly installed metal sheet could cause the pool to collapse. Do not install the metal sheet in windy
weather.
Use the ladder to enter and exit the pool during installation. Take the pool wall
out of the box and place it on top of the box or on a board for easy unravelling.
Ensure that the skimmer cut out is placed on the top part of the metal
sheet, with the opening positioned facing the prevailing wind, so that the
wind blows any impurities towards the skimmer.
Start in the middle of a connecting plate so that the bolts are hidden by a
vertical post. Join the extremities of the metal sheet using the bolts and
washers. The screw heads must be on the inside of the pool and the nuts
on the outside. Ensure that all the bolt holes are used. It is very important for
all the bolts to be adequately tightened to ensure a solid join. To protect the
liner, stick a protection band (duct tape) over the screws on the inside of the
pool.
IMPORTANT: Increase the stability and rigidity of the metal sheet by
provisionally installing the top metal profiles and the vertical posts as
you proceed with the assembly.
Fix the covering plate supports to the posts before assembly. On the lower part,
fix the posts to their connecting plate using 2 screws; on the upper part, fix the
posts to their connecting plate with 2 loosely tightened screws.
2276
OSMOSE Round
2176
121510
M6 nut
66
Skimmer cut outs and
discharge nozzle
Inside
121610
M6 washer
Exterior
0341
0341
Assembly Guide 880114-rev A
121000
M6 screw