Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en-US
Raise the vacuum cleaner into the
vertical position.
Press the release button on the tele-
scopic wand to detach the suction
hose handle (Fig. 17).
For increased stability, turn the elbow
joint at the bottom of the hose down-
wards as illustrated until it clicks into
position above the retainer (Fig. 18).
Unlock the hose connector by turn-
ing it in the direction of the arrow
(Fig. 34).
Now detach the hose connector from
the elbow by pulling it (Fig. 34).
Remove any debris or blockages.
Replace the connector, making sure it
goes on straight. Lock it into position.
If you unable to reach all of the debris,
you can also try the following steps:
Unlock the service cover at the back of
the vacuum cleaner as follows (Fig. 35).
Using a coin, turn the two screws as
far as they will go.
Pry the cover off.
Remove any debris or blockages.
Reinsert the service cover and lock it
using the screws.
22
Cleaning and care
Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Turn off and unplug
it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.
Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents!
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.
Monitor the filter bag change indicator
and inspect all filters regularly. Clean or
replace them when necessary accord-
ing to these Operating Instructions.
Do not let the vacuum cleaner
get wet. If moisture gets into the ap-
pliance, there is a risk of electric
shock.
Publicité
Chapitres
Table des Matières
