Important Safety Advice - EWT CDE2ECC Manuel D'instructions

Cadiz Eco
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Model Description
CDE2ECC Electronic Climate Control
CDE3ECC Electronic Climate Control

Important Safety Advice

If the appliance is damaged, check immediately
with the supplier before installation and
operation.
Warning – This appliance must not be used
in a bathroom.
Warning – Do not use this heater in the
immediate surroundings of a bath, a shower
or a swimming pool.
Warning – This heater must not be located
immediately below a fixed socket outlet.
Warning – Do not use in areas where petrol,
paint or flammable liquids are used or stored.
The heater carries a warning symbol
to alert the user to the risk of fire that
exists if the heater is accidentally
covered
WARNING – THIS APPLIANCE MUST BE
EARTHED
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through
an external switching device, such as a timer,
or connected to a circuit that is regularly
switched on and off by the utility.
This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience or knowledge
if they have been given supervision or
instruction concerning the use of the
appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
Children of less than 3 years should be
kept away unless continuously supervised.
Children aged from 3 years and less than 8
years shall only switch on/off the appliance
provided that it has been placed or installed
in its intended normal operating position
and they have been given supervision
or instruction concerning the use of the
appliance in a safe way and understand
the hazards involved. Children aged from 3
years and less than 8 years shall not plug in,
regulate and clean the appliance or perform
user maintenance.
CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
Watts
If the mains lead is damaged, it must be
2000
replaced by the manufacturer or its service
3000
agent or a similarly qualified person in order
to avoid a hazard.
General
The heater is designed for operation on an AC electricity supply, and is
suitable for use in domestic dwellings and similar indoor locations.
Always ensure that the appliance is stood on a firm, level base near to, but
not directly beneath, a suitable fixed socket outlet.
The heater is fitted with wheels, castors and a handle for ease of movement.
Selector switches provide a choice of heat output and an adjustable
thermostat enables the room temperature to be controlled accordingly. It
is supplied with a cord and plug ready for use.
The supply cord should be uncoiled before use (see 'Storage').
DO NOT pull the heater along by the mains lead.
Important - The heater must only be operated with the wheels and
castors fitted and in the upright position as shown in Fig. 1.
Warning – The heater complies with stringent safety standards but to ensure
efficient operation SURFACES OF THE HEATER WILL BECOME HOT
AND CONTACT WITH THESE AREAS SHOULD BE AVOIDED, particularly
between the air outlet slots on the top and sides.
The control panel area is designed to be at a far lower temperature to allow
the safe operation of the controls at any time.
Momentary contact with any part of the heater should not cause injury.
However aged, infirm persons or young children should not be left
unsupervised in the vicinity of the heater.
Please Note – After switching the heater on for the first time and after
an extended period of non-use a smell may be noticed, this is quite
normal – the fumes are non-toxic and will quickly disappear. We
recommend that you open a window to ventilate the room when using
the heater during this time.
Used in an environment where background noise is very low, it may be
possible to hear a sound which is related to the element. This is normal
and should not be a cause for concern.
Positioning the Heater
Select the position for the heater ensuring there is clearance from any
furniture and fittings of at least 300mm above the heater and 150mm
each side. The appliance should only be operated on a flat stable surface.
Operation
Important – Objects or clothing must not be placed on this heater. Before
using the heater ensure that all warnings and instructions have been read
carefully.
To bring the heater into use plug it in. Neon indicating lights located at the
controls area will glow when the appliance is actually heating.
Controls
On/Off button -
elements.
below the control button.
Electronic Climate Control
Operation
The electronic control allows MANUAL and AUTO operation.
In MANUAL ON mode there are three heat settings :
L/H Side Heat, R/H Side Heat and High Heat
In AUTO mode the heater comes on as per the programmed timer settings
(see Setting programs). At any point if the heater is active i.e. heat is being
produced, the ' ' neon is lit - see Fig. 2.
Initial Operation
When the heater is connected to the mains the ' ' neon will be lit and the
display is blank. Press the '
to 35 C - see Fig. 5.
o
Note: All display characters are displayed in Fig. 10.
Standby Mode
With the heater ON if the '
standby mode, heater switches off, the display goes blank and only
the MAINS ON neon ( ) remains lit. On pressing the '
heater will come on in the mode and with the settings it had prior to going
- 1 -
This button controls the electricity supply to the
When the On/Off button is activated a neon light 'x' illuminates
- see Fig. 2
' button and the display goes to full heat set
' button is pressed, the heater will go into
' button again the