Bras B-Cube 1 Livret D'instructions page 20

EN GLIS H
B-Cube
7. 3. 2 DISMANTLING THE
RECOVER
1
Click open the two parts. (see figure 9).
figure 9
2
Remove the left part of the recover and then
the right part. (see figure 10).
figure 10
7. 3. 3 CLEANING
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source.
IMPORTANT
Do not attempt to wash any machine
components in a dishwasher.
1
Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-140 °F)
potable water and dishwashing detergent. Do not
use abrasive detergent.
Important: if present, follow label directions, as
too strong a solution can cause parts damage,
while too mild a sol uti on will not prov ide
adequate cleaning.
IMPORTANT
In order to prevent any damages to the
dispenser use only a detergent suitable
with plastic parts.
2
Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in the
cleaning solution.
ATTENTION
When cleaning the machine, dump it, do
not allow excessive amounts of water
around the
components of the unit. Electrical shock or
damage to the machine may result.
3
In the same manner clean the evaporator
cylinder(s) using a soft bristle brush.
4
Rinse all cleaned parts with cool clean water.
7. 3. 4 SANITIZING
Sanitizing should be performed immediately
prior to starting the machine. Do not allow the
unit to sit for extended periods of time after
sanitization.
Sanitization must be performed whenever the
20
electrically operated