Publicité
Les langues disponibles
Les langues disponibles
4
To Adjust Saw Chain Tension.
1.
Loosen two guide bar nuts (C), if necessary.
2.
Turn saw chain adjuster slot (E) clockwise to tighten saw chain on
guide bar. Turning slot counter clockwise will loosen saw chain
on guide bar.
3.
Tighten guide bar nuts (C) firmly. Pull the saw chain around the
guide bar by hand. Saw chain should move freely on guide bar.
If saw chain is difficult to rotate or binds on guide bar, it is too
tight.
4.
Keep the saw chain lubricated and properly adjusted and the
guide bar nuts tightened firmly at all times.
adjusTIng auTOMaTIc OIlEr
1.
Remove two (2) 6 mm guide bar retaining nuts (C) and sprocket
cover (D).
2.
From bottom of gear case, turn adjustment screw (P) clockwise to
decrease oil volume - counter clockwise to increase oil volume.
3.
Install sprocket guard (D) and secure with two (2) guide bar
retaining nuts (C).
note
Very little visible oil on the saw chain will provide sufficient lubri-
cation.
eCHo ConSUMeR PRoDUCt SUPPoRt: If you require as-
sistance or have questions concerning the application, operation or
maintenance of this product you may call the ECHO Consumer Product
Support Department at 1-800-673-1558 from 8:30 am to 4:30 pm
(Central Standard Time) Monday through Friday. Before calling, please
know the model and serial number of your unit to help your Consumer
Product Support Representative.
RePLACeMent MAnUALS: Operator's, Parts, and Safety Manu-
als may be obtained from ECHO, or may be downloaded free from
ECHO's website. Make sure you know the model number and serial
number of your unit so you can obtain the correct manual.
P
ower
I
I
nsTallaTIon
nsTrucTIons
c
D
c
D
P
ECHO, inCOrPOraTED
400 OaKwOOD rOaD
LaKE ZUriCH, iL 60047-1564
PHOnE: 1-800-673-1558
www.echo-usa.com
P
TM
runer
E
Publicité
