GYS NOMAD POWER PRO 90 Mode D'emploi page 8

Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
•The battery must be removed from the device before the latter is
discarded.
•The device must absolutely be disconnected from the power supply
network before removing the battery.
OPERATION
Indicators
Lights
Internal battery
capacity for the
device
Indicators flash in turn, whilst charging the device. 3. The green LED indicator will be illuminated when NOMAD POWER PRO is fully charged (It needs to be charged
when the orange LED indicator is illuminated in).
!
RECHARGE THE NOMAD POWER before first use and after each use.
INTERNAL BATTERY CHARGING
OR
STARTING THE VEHICLE
Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
!
If the NOMAD POWER voltage is inferior to the vehicle voltage, the NOMAD POWER will not operate.
1
2
8
NOMAD POWER PRO 90
Press the ON/OFF button to check internal battery level of the NOMAD POWER PRO.
Red Orange
25% 50%
1 - Connect mains adaptor to domestic mains.
2 - Connect the other end to the NOMAD POWER PRO to start the charge.
Disconnect the charger when the green LED indicator is on.
1 - Connect car adaptor to the car cigarette lighter socket.
2 - Connect the other end to the NOMAD POWER PRO to start the charge.
Disconnect the charger when the green LED indicator is on.
Make sure the battery terminals on the vehicle to be boosted are well cleaned with no grease or corrosion.
Connect the booster cable plug into the booster cable socket.
Yellow Green
75% 100%
EN