Blade Descriptions; Unpacking Your Saw - DeWalt DW718 120 Volt Guide D'utilisation

Adjustable Length Stop: DW7051
Requires the use of one work support (see drawing). It is used to make
repetitive cuts of the same length from 0 to 42".
Clamp: DW7082 (similar model included)
Used for firmly clamping workpiece to the saw table for precision cutting.
Dust Bag: DW7053 (Included with some models)
Equipped with a zipper for easy emptying, the dust bag will capture the
majority of the sawdust produced (not shown).
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
SAW BLADES: ALWAYS USE 12" SAW BLADES WITH 1" ARBOR HOLES.
SPEED RATING MUST BE AT LEAST 4800 RPM. Never use a smaller
diameter blade. It will not be guarded properly.

BLADE DESCRIPTIONS

APPLICATION MODEL #
Construction Saw Blades (thin kerf with anti-stick rim)
General Purpose DW3123
Fine Crosscuts DW3126
Fine Crosscuts DW3128
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts DW7648
Fine crosscuts DW7649
Ultra-fine crosscuts DW7650
Laminates DW7661
Solid surface
and plastics DW7668
Non-ferrous metals DW7666

Unpacking Your Saw

Check the contents of your miter saw carton to make sure that you have received
all parts. In addition to this instruction manual, the carton should contain:
1. One DW718 miter saw.
2. One D WALT 12" diameter saw blade.
E
3. One blade wrench in wrench pocket shown in Figure 4.
4. One DW7053 Dustbag (some models).
5. One material clamp.
TOOTH
DIAMETER TEETH GRIND
12" 32 ATB
12" 60 ATB
12" 80 ATB
12" 60 ATB
12" 80 ATB
12" 96 ATB
12" 80 TCG
12" 80 Mod TCG
12" 80 TCG
DW7080
END
PLATE
LOCKNUTS
DW7082
4
KNOBS
DW7084
DW7051
BRACKET