Fein Turbo II X Série Mode D'emploi page 6

OBJ_BUCH-0000000234-002.book Page 6 Tuesday, August 1, 2017 8:47 AM
en
6
4) Vacuum cleaner use and care
a) Do not overload the vacuum cleaner.
Use the vacuum cleaner intended for
your work. The correct vacuum cleaner
will do the job better and safer at the
rate for which it is designed.
b) Do not use a vacuum cleaner that has a
defective switch. A vacuum cleaner that
cannot be controlled with the switch is
dangerous and must be repaired.
c) Before carrying out adjustments on the
vacuum cleaner, replacing accessories
or placing down the vacuum cleaner,
pull the plug from the socket outlet. This
safety measure prevents accidental
starting of the device.
d) Store idle vacuum cleaners out of the
reach of children. Do not allow persons
unfamiliar with the vacuum cleaner or
these instructions to operate the vac-
uum cleaner. Vacuum cleaners are dan-
gerous in the hands of untrained users.
Special safety instructions.
This vacuum cleaner is not intended to be
used by persons (including children) with lim-
ited physical, sensory or mental capabilities,
or lack of experience and/or knowledge.
Supervise children. This will ensure that chil-
dren do not play with the vacuum cleaner.
Persons operating this vacuum
WARNING
cleaner must be properly
instructed in how to use it. Before using, the
person operating the vacuum cleaner must be
provided with information, instructions and
training on the use of the vacuum cleaner and
the materials for which it is to be used,
including the safe handling for disposal of the
materials having been vacuumed. The person
operating the vacuum cleaner must observe
the valid safety regulations for the materials
being handled.
Wear personal protective equipment. Depend-
ing on application, use face shield, safety
goggles or safety glasses. Where appropriate,
wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping
small abrasive or workpiece fragments. The
safety glasses must be capable of protecting
against flying particles generated by the vari-
ous operations. Prolonged exposure to high
intensity noise may cause loss of hearing.
e) Maintain the vacuum cleaner with care.
Check for misalignment or binding of
moving parts, breakage of parts and any
other condition that may affect the vac-
uum cleaner's operation. Have damaged
parts repaired before using the vacuum
cleaner. Many accidents are caused by
poorly maintained vacuum cleaners.
f) Use the vacuum cleaner, accessories,
etc. according to these instructions and
as specified for this specific type of
device. Take into consideration the work-
ing conditions and the activities to be
carried out. Use of vacuum cleaners for
operations different from those intended
could result in hazardous situations.
5) Service
a) Have your vacuum cleaner repaired only
through a qualified repair person and
only using original replacement parts.
This will ensure that the safety of the
vacuum cleaner is maintained.
Operate the vacuum cleaner only from
grounding outlets that are according to regu-
lations. Only use undamaged supply cords and
regularly checked extension cords with
ground contact. A protective conductor with-
out continuity can lead to electric shock.
The grounded connection socket discharges
static charges. In connection with electro-
statically discharging accessories (optional),
this prevents the formation of sparks and cur-
rent surges.
When wet vacuuming, operate the vacuum
cleaner only when the container is level. Oth-
erwise there is danger of electric shock from
water penetrating into the vacuum cleaner's
motor.
Do not misuse the power supply cord to pull
the vacuum cleaner around or pull the mains
plug from the socket outlet. Keep the power
supply cord away from heat, oil, sharp edges,
or rotating parts. Do not drive over or pinch
the power supply cord. Damaged or entangled
power supply cords increase the risk of an
electric shock.
Before replacing accessories, pull the mains
plug from the socket outlet. This safety mea-
sure reduces the risk of electric shock.