Fein Turbo II X Série Mode D'emploi page 24

OBJ_BUCH-0000000234-002.book Page 24 Tuesday, August 1, 2017 8:47 AM
en
24
Troubleshooting.
Malfunction
Vacuum cleaner cannot be
switched on.
Reduced vacuuming capacity. Vacuum cleaner not
Dust escapes during vacuum-
ing.
No suction capacity when wet
vacuuming.
The automatic shut-off (while
wet vacuuming) does not
respond.
Automatic filter cleaning (AC)
inoperative.
The automatic filter cleaning
(AC) cannot be switched
on/off.
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed. In addition, FEIN also provides a guarantee in accordance with the FEIN
manufacturer's warranty declaration.
Not all accessories described or shown in this instruction manual will be included with your-
power tool.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should be sorted for environmental-friendly
recycling.
For further information, please contact your specialist shop.
Possible Cause
Circuit breaker of
power supply has
tripped.
Vacuum cleaner in
remote control
operation.
fitted correctly.
Vacuum system
clogged.
Fleece filter bag full.
Flat-fold filter full.
Disposal bag full.
Incorrect mounting
position of flat-fold
filter.
Container full.
Sensors contaminated/
dirty.
Container full.
Vacuum hose not
connected.
Corrective Action
Ensure power supply.
Set operating-mode selector to "I".
Mount lid properly and shut both
fasteners completely.
Clean vacuum hose and extension
tubes.
Replace fleece filter bag.
Replace flat-fold filter.
Replace disposal bag.
Correct mounting position of flat-
fold filter.
Empty container.
Clean sensors and their
intermediate space using a brush.
For electrically non-conductive
liquids, check filling level and empty
container, as required.
Connect vacuum hose.
Contact the FEIN Customer
Service.