Filling The Engine With Oil - Toro Power Max 726 Manuel De L'utilisateur

Figure 9
1. Short rod
4. Insert the front end of the rod into the opening in
the back of the chute gear cover until it slides into the
chute gear (Figure 10).
Figure 10
5. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose parts bag) through
the short rod from the left side of the machine (from
the operating position).
6. Insert the cable clip that supports the deflector
cable onto the forward carriage bolt, and secure the
carriage bolts with locknuts from the loose parts bag
(Figure 11).
2. Long chute control rod
g018885
1. Cable clip
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5

Filling the Engine with Oil

No Parts Required
Procedure
Your machine comes with oil in the engine crankcase.
Note: Before starting the engine, check the oil level and
add oil if necessary.
Use automotive detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher. Refer to your engine owner's
manual.
Use Figure 12 below to select the best oil viscosity for the
outdoor temperature range expected:
g019049
Engine Oil Capacities
10
Figure 11
2. Deflector cable
Figure 12