Safety Instructions - Klarstein 10034674 Mode D'emploi

EN
16

SAFETY INSTRUCTIONS

• Remove the packaging and make sure that the appliance is intact. If in doubt, do
not use it and contact qualified personnel only.
• Packaging materials (plastic bags, polystyrene, staples etc.) Must be kept out of the
reach of children as they could be hazardous.
• This device may be only used by children 8 years old or older and persons with
limited physical, sensory and mental capabilities and / or lack of experience
and knowledge, provided that they have been instructed in use of the device by a
responsible person who understands the associated risks.
• Before connecting the appliance, check that the appliance rating corresponds to
the mains rating.
• This appliance must only be used for the purpose for which it has been
manufactured. As a stand fan. The manufacturer is not responsible for any damage
caused by improper or incorrect use.
• The installation/assembly of the device will be made according to the indications of
the manufacturer. A wrong procedure may cause damages to persons, animals or
objects, for which the manufacturer cannot be considered responsible
• Before cleaning or carrying out maintenance on the appliance, disconnect it from
the electrical mains by removing the plug from the electrical outlet or by switching
off the system switch.
• If the appliance is faulty and/or operating incorrectly, switch it off without
tampering with it. If the above is disregarded, the safety of the appliance may be
compromised.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
• Do not power the device using multiple sockets.
• Do not use adapters and/or extension cable
• The device must not be switched on using external timers and/or other remote
control devices which are not specified in this manual.
• Do not use or store the device near heat sources (heaters, stoves).
• Do not dip the device in water or other liquids; in case the accidental fall in the
water do not try to take it out, but first of all unplug immediately the power cable
from the socket.
• If you use the device for the first time, make sure to remove any label or protective
sheet which blocks its proper functioning.
• Plug and unplug the power cable with dry hands and hold it firmly.
• Before plugging the plug into a wall outlet, make sure that the unit is switched off.
• Always unplug the power cable to avoid the overheating and avoid stretching it.
• Make sure that all air intakes and outlets are free and not covered so that the unit
does not overheat.
• Avoid placing the power cable on abrasive or sharp surfaces or in positions where
it can be damaged easily.