Assembly And Use; Other Considerations - Capital Safety DBI SALA 8562894 Manuel D'instructions

3.0

ASSEMBLY AND USE

WARNING: Do not alter or intentionally misuse this equipment. Consult with Capital Safety if using this
equipment in combination with components or subsystems other than those described in this manual. Some
subsystems and components combinations may interfere with the proper operation of this equipment. Use
caution when using this equipment around moving machinery, electrical and chemical hazards, and sharp
edges.
WARNING: Working at height has inherent risks. Some risks are noted here but are not limited to the
following: falling, suspension/prolonged suspension, striking objects, and unconsciousness. In the event of a
fall arrest and/or subsequent rescue (emergency) situation, some personal medical conditions may affect your
safety. Medical conditions identifi ed as risky for this type of activity include but are not limited to the following:
heart disease, high blood pressure, vertigo, epilepsy, drug or alcohol dependence, psychiatric illness, impaired
limb function and balance issues. We recommend that your employer/physician determine if you are fi t to
handle normal and emergency use of this equipment.
3.1 BEFORE EACH USE inspect this equipment according to steps listed in section 5.2. Do not use this equipment
if inspection reveals an unsafe or defective condition. Plan your use of the fall protection system prior to
exposing workers to dangerous situations. Consider all factors affecting your safety before using this system.
A. Read and understand all manufacturer's instructions for each component of the personal fall arrest
system. All Capital Safety harnesses and connecting subsystems are supplied with separate user
instructions. Keep all instructions for future reference.
B. Review sections 1.0 and 2.0 to ensure system limitations and other requirements have been adhered to.
Review applicable information regarding system clearance criteria, and ensure changes have not been
made to the system installation, or occurred at the job site, that could affect the required fall clearance.
Do not use the system if changes are required.
C. The Counterweight Base/Rack system is intended for use only where the user remains in an area
immediately (no more that 5° from vertical) below the davit arm attachment or suspension point.
3.2 PLAN your fall arrest or rescue system before starting your work. Take into consideration factors affecting your
safety at any time during use. The following list gives some important points you must consider when planning
your system:
A. ANCHORAGE: Make sure the anchorage or work surface is rigid and capable of supporting the required
loads. See section 2.4. Locate the system in accordance with section 3.3.
B. SHARP EDGES: Avoid working where the connecting fall arrest or rescue subsystem (i.e. SRL, lanyard,
lifeline, etc.) or other system components will be in contact with, or abrade against unprotected sharp
edges. If working with this equipment near sharp edges is unavoidable, protection against cutting must
be provided by using a heavy pad or other means over the exposed sharp edge.
C. RESCUE: Should a fall occur, the user (employer) must have a rescue plan and the means at hand to
implement it.
D. AFTER A FALL: Any equipment which has been subjected to the forces of arresting a fall must be
removed from service immediately and destroyed or contact a factory authorized service center for repair.
E.

OTHER CONSIDERATIONS:

• The counterweight system is intended to be used by only one person.
• Personal fall arrest systems must be rigged to limit any free fall to a maximum of 6 ft. (1.8 m) (OSHA
and ANSI Z359.1).
• Do not allow a lifeline to pass under arms or between legs.
4