CYBEX RUBY Mode D'emploi page 6

2. ASSEMBLING THE HANDLES
ATTENTION: THE PINS ON BOTH SIDES MUST BE ENGAGED.
3. ASSEMBLING THE FRONT WHEELS
– Fit the front wheels to the end of the frame until they engage with a "click".
4. ASSEMBLING THE REAR WHEELS
ATTENTION: THE WHEEL SYSTEM WITH THE BRAKE PEDAL MUST BE FITTED TO THE RIGHT
SIDE OF THE BUGGY (VIEWED BEHIND THE BUGGY).
ATTENTION: THE PINS ON BOTH SIDES MUST BE ENGAGED.
TAKE A LOOK THAT THE BOWDEN CABLE IS INSERTED INTO THE CLIP ON BOTH SIDES.
5. FOLDING THE STROLLER
Remove all contents from the basket. Close the basket. Remove the bumperbar.
a) Push the primary lock lever underneath the pedal button.
b) Lift the activated primary lock lever to release the stretching system.
c) Push down the secondary lock lever (extended bar on the right side of the
locking system, see picture 3).
d) Grip handles and push forward on the stroller to fold it.
e) Press folded stroller until the fold lock is engaged. Its recommended to fasten
the harness before folding the stroller.
6. OPENING THE STROLLER
a) Release the fold lock lever.
b) Open the stroller
c) Push the pedal button down until the locking system is engaged.
WARNING: ENSURE THAT ALL LOCKING DEVICES ARE ENGAGED BEFORE USE.
7. USING THE BRAKES
a) Engage Brake
b) Release Brake
8. AUTOMATIC FRONT WHEEL SWIVEL LOCKS – LOCK
a) Push the Front Swivel Lock Lever until it "clicks". It can be activated in any wheel
positions. The swivel Lock will engage automatically when it reaches the right
position.
b) Lift the Front Swivel Lock Lever up again to release the Swivel Lock.
9. CANOPY
– Attach the canopy adaptor on to the inside of the frame tubes of the buggy.
– To remove the canopy reverse procedure.
– The canopy is adjustable to various positions.
The canopy has a fully ratcheting function to create complete coverage. Simply
pull on the front of the canopy to the desired position. The height can be easily
adjusted by simply sliding the canopy up or down the frame. The entire canopy
can also be tilted forward. For maximum coverage, unzip the extra panel on top
of canopy and pull forward.
8
– The canopy flap at the rear of the stroller can be rolled up and fixed with a
velcro fastener, if required.
10. USING THE HARNESS SYSTEM
a) To fasten the harness system – insert left and right side fasteners into the central
harness buckle.
b) Adjust the shoulder straps with the corresponding sliders.
c) To release fasteners squeeze the grooves on left and right side of the central
harness buckle to release the belts.
WARNING: ALWAYS USE THE CROTCH STRAP IN COMBINATION WITH THE WAIST BELT.
11. REMOVING THE SEAT COVER
Slightly fold the stroller to reduce tension. Remove hood from stroller, if fitted.
a) Detach the seat cover's hooks from the frame on left and right side
b) Detach the seat cover's hooks of the recline system from the frame.
c) Open the press buttons behind the legrest to detach it from the frame tubes.
d) Open straps underneath the seat cover.
e) Feed the shoulder strap end sliders through the holes in the backrest.
f) Feed harness straps with fasteners through the holes in the seat cover. Take off
seat cover.
Reverse this procedure to refit the seat cover and harness.
WARNING: CHECK THAT THE SEAT UNIT IS CORRECTLY ENGAGED BEFORE USE.
12. RECLINING THE SEAT
The CYBEX RUBY has two different recline positions.
a) To recline the backrest pull out the hooks on left and right side of the front tubes.
b) Then hook them into the corresponding supports on the rear tube.
c) Ensure that the hooks are fastened properly before you put your child back into
the seat.
WARNING: NEVER RECLINE THE SEAT WHILE YOUR CHILD IS IN IT.
13. CARRYING THE STROLLER
– Pull the flexible carry handle on left rear tube and lift the stroller.
14. ASSEMBLING THE BASKET
a) Slide the two front loops of the basket over the seat tubes.
b) Feed the two velcro straps on both sides into the attachment brackets.
c) Hook the two rear loop straps into the rear brackets.
Reverse this procedure to take the basket off.
15. ATTACHING THE RAINCOVER (OPTIONAL)
a) Extend the rain cover over the stroller like shown in the image
b) To fit the rain cover fasten the velcro strips around the frame at the top and
bottom on both sides of the buggy.
16. WARRANTY
The following warranty applies solely in the country where this product was initially
sold by a retailer to a customer. The warranty covers all manufacturing and material
defects, existing and appearing, at the date of purchase or appearing within
a term of two (2) years from the date of purchase from the retailer who initially
sold the product to a consumer (manufacturer's warranty). In the event that a
manufacturing or material defect should appear, we will – at our own discretion –
either repair the product free of charge or replace it with a new product. To obtain
such warranty it is required to take or ship the product to the retailer, who initially
sold this product to a customer and to submit an original proof of purchase (sales
receipt or invoice) that contains the date of purchase, the name of the retailer and
the type designation of this product. This warranty shall not apply in the event that
this product is taken or shipped to the manufacturer or any other person other than
the retailer who initially sold this product to a consumer. Please check the product
with respect to completeness and manufacturing or material defects immediately
at the date of purchase or, in the event that the product was purchased in distance
selling, immediately after receipt. In case of a defect stop using the product and
take or ship it immediately to the retailer who initially sold it. In a warranty case the
product has to be returned in a clean and complete condition. Prior to contacting
the retailer, please read this instruction manual carefully. This warranty does not
cover any damages caused by misuse, environmental influence (water, fire, road
accidents etc.) or normal wear and tear. It does solely apply in the event that the
use of the product was always in compliance with the operating instructions, if any
and all modifications and services were performed by authorized persons and if
original components and accessories were used. This warranty does not exclude,
limit or otherwise affect any statutory consumer rights, including claims in tort and
claims with respect to a breach of contract, which the buyer may have against
the seller or the manufacturer of the product.
17. CARE INSTRUCTIONS
– wash separately
– gentle action wash warm water
– do not bleach
– do not tumble dry
– do not iron
– do not dry clean
UK – After sales Service:
If you need assistance, spare parts or you are unhappy with any aspect
of the goods please contact Customer Care on: +44 (0)845 268 2000,
or e-mail us at: customer.care@mamasandpapas.com.
Visit our website at www.mamasandpapas.com for the latest product
information.
9