Operating Procedures; Starting The Engine - Firman SPS2000i Manuel Du Propriétaire

5. OPERATING PROCEDURES

STARTING THE ENGINE

(a) Make certain the generator is on a flat, level surface.
(b) Disconnect all electrical loads from the generator.Never start or stop the
generator with electrical devices plugged in or turned on.
(c)Turn the fuel cap vent lever to the "ON" position.
(d) Turn the fuel valve to the "On" position.
(e) Pull choke lever out to the "Choke" position.
(f) Turn the engine switch to the "On" position.
(g)Pull the starter cord slowly until resistance is felt and then pull rapidly.
(h) As engine warms up, push the choke lever to the "Run" position.
OFF
ON
Page 13