Philips Multigroom 3000 Série Mode D'emploi page 7

Using the appliance
Warning: Always check the appliance before you use it. Do not use the
appliance if it is damaged, as this may cause injury. Always replace a
damaged part with one of the original type.
Note: The appliance can only be used without cord.
Detaching and attaching cutting elements
1 To detach a cutting element, turn it anti-clockwise and pull it upwards
off the handle (Fig. 5).
2 To attach a cutting element, place it on the handle and turn it
clockwise (Fig. 6).
Detaching and attaching combs
1 To detach any type of comb from the cutting element, press the length
setting selector, grab the sides and pull it upwards off the cutting
element (Fig. 7).
2 To attach any type of comb onto a cutting element, slide it into the
guiding grooves on both sides of the handle (Fig. 8).
Switching the appliance on and off
1 To switch on the appliance, slide the on/off button up (Fig. 9).
2 To switch off the appliance, slide the on/off button down.
Precision attachments for use on face
Nose trimming
You can use the nose trimmer attachment to trim your nose hair and ear
hair.
- Make sure your nostrils are clean. Make sure your outer ear channels
are clean and free from wax.
- Do not insert the tip more than 0.5cm and make controlled
movements.
Nose trimmer rotary
Trimming nose hair:
- Gently move the tip in and out of your nose while turning it round to
remove unwanted hairs (Fig. 10).
Trimming ear hair:
- Slowly move the tip round the ear to remove hairs that stick out
beyond the rim of the ear.
English
7