Mounting 5-Color Changer; Angle Adjustments - Leviton LEO Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MOUNTING 5-COLOR CHANGER

• Position 5-Color Changer on front plate of fixture (ensure color levers are on right side when viewed from behind fixture)
• Line up mounting holes with screws and attach, sliding 5-Color Changer down into position
• Tighten mounting screws with long screwdriver
NOTE: 5-Color Changer is also equipped with a drop-in runner slot for color/diffusion media (190 mm x 190 mm).
NOTE: Always close the 5-Color Changer when transporting or storing the fixture.
Screw
Screw
Screw
Position
over
Screws

ANGLE ADJUSTMENTS

LEO™ LED Follow Spot can be panned, tilted up and down to position the light where it is needed.
• Loosen the yoke-fastening lever, while holding the fixture steady with the side handle or rear handle of the fixture.
• With the fixture turned ON, use the handles and tilt it to the desired angle.
• Tighten the yoke-fastening lever once positioned.
Rear Handle
Yoke Fastening Lever
Slide Down
4
Side Handle
Tighten

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

LedfsLeo ledfs

Table des Matières