Mounting; Mounting To Tripod; Alternate Yoke Mount - Leviton LEO Mode D'emploi

MOUNTING

LEO™ LED Follow Spot is fitted with a mounting yoke. The yoke has a 0.5" (13mm) hole for the attachment of a Ø 29mm
spigot. Ensure the structure you are mounting to can support the load of the fixture.
• Always mount this product in a safe position with adequate ventilation and away from a heat source - minimum 20"
(50 cm) from adjacent surface.
• DO NOT operate product near flammable materials - minimum 8" (20 cm) from adjacent surfaces.
• LEO™ LED Follow Spot may be operated in any position (max. tilt +45° to -45° from horizontal and panning freely).
NOTE: Ensure there is adequate room for ventilation, configuration, and maintenance.

MOUNTING TO TRIPOD

LEO™ LED Follow Spot can also be mounted to a Follow Spot tripod. Ensure it is mounted securely using the 3/8" (9.5mm)
spigot adapter and hex nut provided with the tripod. NOTE: If your tripod is provided with wheels, the wheels should be
installed prior to attaching the fixture to the tripod. When the Follow Spot is mounted to a tripod, the base width of the tripod
must be a minimum of 32" (81 cm) in diameter and the mounting height of the Follow Spot yoke must not exceed 44" (112 cm).

ALTERNATE YOKE MOUNT

NOTE: The yoke mounting position can be adjusted to accommodate varying weights of different accessories. The fixture
comes mounted to the adjustment hole closest to the lens to accommodate the 5-Color Changer. If using the fixture without
the 5-Color Changer, use the alternate mounted hole for better balance.
Hex Nut
Yoke Mounting
without
5-Color Changer
3
Yoke
Tripod
Yoke Mounting
with
5-Color Changer