patura 323910 Instructions De Montage page 13

Montageanleitung / Instructions de montage
Installation Instructions / Montagehandleiding
Indicaciones de montaje
3. Mounting support frame
Place the pipe clamps on both sides of the round tube and screw them tight.
Loosen the clamping screws in the mounting plates
Slide the square tube into the mounting plate
the mounting plate
4
Position the finger gate
4.
Now tighten all screws of the support frame (not the screws of the T-pieces of the finger module).
Screw the posts to the support frame using the full clamps 90 x 90 mm or 102 mm. Please make sure that the mounting
5
plate is on the drive side of the post
4
When using anchors for slatted floor
1
on both sides and clamp the square tube. Tighten the clamping screws of
4
.
. Now the entire frame must be set up (maintain a clear passage height of 2.00 m).
5
, these must be threaded into the base plate of the posts, before installation.
7
Walk-out
to be able to push the square tube through.
4
6
4
5
Walk-in