Troubleshooting - Pushbutton - Storch ColorFree top Mode D'emploi

Troubleshooting
In rare cases, the booster pump may not start when the ball valve on the Tur-
bo-Wash is opened. This is caused by an extended period of non-use, water
with a high lime content or a combination of the two. For this case, the pump
is equipped with a pushbutton (1) switch that can be used to perform a Quick-
Start. Proceed as follows:
1. Turn on the water supply line for the splitting unit
2. Open the ball valve on the TurboWash
3. Press and hold the QuickStart button (1) for 5 seconds
4. Close the ball valve of the Turbo-Wash again
5. The pump should now start when the ball valve is opened again
Translation of the original instruction
1
Button
68