Storch ColorFree top Mode D'emploi page 67

7. Route the water hose with seal supplied with the TurboWash through
the lower opening on the back of the unit and attach it to the vhorizontal
threaded connection of the pump; attach the other end to the TurboWash.
Fit both screw connections with one of the supplied seals.
8. Open the water tap of the water supply line and the ball valve on the Tur-
boWash and check all screw connections for leaks.
9. If all connections are tight, connect the system to the mains, switch it on
and check the pump for leaks again during operation.
10. Put the cover plate back in place and screw it tight.
The pump is now ready for operation.
ATTENTION
-
While the system is not in operation, always switch it off and shut off the
water supply line!
-
Make absolutely sure that the water supply line is always opened first
before switching on the system and before operating the TurboWash!
67 Translation of the original instruction