Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.
Power-on
●
Check for completion of indoor/outdoor unit wiring.
●
Ensure that covers have been replaced on electrical component boxes for both indoor and outdoor
units prior to restoring power.
5-1
The following are displayed after
power-on.
"Checking the connection.
Please stand by."
During above display, the
backlight will not be available.
When 1 indoor unit is
controlled by 2 remote
controllers:
Be sure to set sub remote
controller during above display.
Press and hold 4 seconds or
longer the Operation mode
selector button of the remote
controller to be set.
When the display is changed from
main remote controller to sub
remote controller, the setting is
completed.
5-2
Basic screen is displayed.
NOTE
If sub remote controller is not set at power-on in the case
of one indoor unit controlled by two remote controllers,
"Error code: U5" is displayed in the connection checking
screen.
Select the sub remote controller by pressing the
Operation mode selector button of either one of the
remote controllers for 4 seconds or longer.
If the basic screen is not displayed more than 2 minutes
after "Sub RC" display, shut off the power supply and
check the wiring.
NOTE
When selecting a different language, refer to
12
<Main remote controller>
5-
1
Off reminder Timer
Checking the connection.
Please stand by.
Main RC
Error Code U5
Checking the connection.
Please stand by.
Main RC
<Basic screen>
5-
2
Fan
Set temperature
28
Return Press the menu button
12
Language
.
(See page 21.)
<Sub remote controller>
5-
1
Off reminder Timer
Checking the connection.
Please stand by.
Main RC
Error Code U5
Checking the connection.
Please stand by.
Main RC
Press and hold 4 seconds
or longer the Operation
mode selector button of sub
remote controller side.
°C
Off reminder Timer
Checking the connection.
Please stand by.
Sub RC
<Basic screen>
5-
2
Fan
Return Press the menu button
.
Set temperature
28
°C
English
Publicité
Chapitres
Table des Matières
