Table des Matières
Publicité
Screw into place and if needed cut
the screws down to size and file to
ensure no sharp edges.
Cover the screw holes with the
blanking plugs supplied to ensure a
neat finish (Fig. 10).
Push fit the 4-way locking handle into
place (Fig. 10).
Your Petsafe cat flap is now ready to
use.
USING YOUR 4-WAY LOCKING SYSTEM
The 4-way lock allows you to control your cat's access in and out of your
home.
In only (Fig. 13)
Out only (Fig. 14)
In or Out (Fig. 15)
Fully locked (Fig. 16)
FIG. 14
FIG. 15
FIG. 10
FIG. 13
FIG. 16
POWERING THE INFRA RED UNIT
Remove the hinge cover by pushing in the direction of the arrow
(Fig. 17).
Place 4 x AA 1.5V Alkaline Long Life batteries in position (Fig. 18).
Batteries should be replaced every 12 months. Do not use rechargeable
batteries
After you have powered the cat flap it emits a low tone beep indicating
the cat flap is ready for programming. In addition to the beep the red LED
will flash.
FIG. 17
FIG. 18
5
Publicité
Table des Matières
