Grill & Fan Blade Assembly; Remote Control Battery Installation - Black & Decker BFSD116B Manuel D'instructions

ENGLISH
SET UP & USE
GRILL & FAN BLADE ASSEMBLY
WARNING: Never attempt to run the fan without the grill in place and properly
1. Remove the spinner and the plastic nut from the front of the motor shaft by
turning the spinner clockwise and the plastic nut counterclockwise. Place the rear
grill so it sits perfectly flush with the front of the motor housing. Secure with the
plastic nut. Insert the provided plastic ring in the center of the rear grill
(see Fig. 5).
2. Insert the center hole of the large blade into the motor shaft first, followed by
the small blade. Screw the spinner counter clockwise to tighten the blades
(see Fig. 6).
3. Making sure the buckle on the front grill is in open position, align the front grill
directly over the rear grill so the 2 fasteners snap into place inside the edge of the
rear grill. Secure by closing the buckle.
Plastic Nut

REMOTE CONTROL BATTERY INSTALLATION

1. Press down on the battery compartment cover and slide it out.
2. Insert 2 "AAA" batteries (not included) making sure that the positive terminals are
facing the proper way.
3. Replace the cover.
NOTE: Use size "AAA" alkaline batteries. Do not use rechargeable batteries.
Page 8
secured. Failure to have the grill in place can result in serious injury.
Fig. 5
Large Blade
Small Blade
Spinner
Spinner
Tight
Loose
Remote Control
Fig. 6
Battery
Battery Cover
Fig. 7
Align the
front grill
Buckle