Black & Decker BFSD116B Manuel D'instructions page 7

SET UP & USE
ASSEMBLY
ASSEMBLING THE BASE, EXTENSION POLE, ADJUSTABLE POLE,
AND MANUAL CONTROL PANEL
1. Unscrew the 7-shaped Bolt to remove the bolt and washer from the Extension
Pole (see Fig. 1).
2. Align the extension pole over the base, making sure that the hole in the
extension pole align with the hole in the base. Align washer and insert the
threaded end of the 7-shaped Bolt into the base turning clockwise to tighten into
base until secure.
3. Loosen the height adjustment ring by turning to the right and pull out the
adjustable pole to extend it. Adjust the pole to the desired height and tighten the
height adjustment ring
NOTE: If you can't find the internal, adjustable pole, it has slid inside the
extension pole. You will need to retrieve it by pulling it out from the extension
pole (see Fig. 3).
4. To attach the upper portion of the fan to the extension pole, loosen the thumb
screw slightly on the bottom of the unit head. Place the unit head on the
extension pole and tighten the thumb screw in alignment with the groove on the
internal pole (see Fig 4).
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Loosen
Mounting Hole
Thumb Screw
Groove
ENGLISH
Page 7