Replacing The Alarm Batteries - Schlage FE575 Guide D'utilisation

REPLACING THE ALARM BATTERIES

1. Remove the lock from the door.
PROBLEM
There is a delay before unlock
after a valid User Code is
entered.
blinking red but no
codes have been entered.
Cannot add a new User Code.
Cannot delete a User Code.
Cannot change Programming
Code.
Cannot delete all User Codes.
Lock will not stay in
programming mode.
* Beeps sound on keypad only when beeper is enabled.
2. Replace the AAA batteries in the lever.
SOUNDS* LIGHTS
High/Low, Red then
then 1 Green
— Quick Red
Blinking
High/Low Red
2 Red
2 Red
2 Red
2 Red
2 Red
SOLUTION
Battery is low and should be replaced. See Replacing the
Keypad Batteries on page 8.
Battery is dead and MUST be replaced. See Replacing the
Keypad Batteries on page 8.
19 User Codes already exist. Delete a User Code before
adding a new one. See the Keypad Locks Programming
Guide.
Second User Code entered did not match first User Code
entered.
The User Code matches the first four digits of the existing
Programming Code.
Second User Code entered did not match first User Code
entered.
Second Programming Code entered did not match first
Programming Code entered.
First four digits of new Programming Code match an
existing User Code.
Programming code entered second time is incorrect.
Any key other than
programming mode was entered.
An incorrect entry was made during the programming
process. See the Keypad Locks Programming Guide.
3. Replace the lock
on the door.
was pressed immediately after
9