Using The Keypad; User Codes And Keypad Programming; Locking And Unlocking - Schlage FE575 Guide D'utilisation

USING THE KEYPAD

User Codes and Keypad Programming

The Keypad Locks Programming Guide (see separate
document included in this package) contains the following
information:
• Factory Preset Programming Code
• Factory Preset User Codes
• Instructions for adding and deleting User Codes and
changing the Programming Code

Locking and Unlocking

• The lock is always locked from the outside. It is not
necessary to lock the lock from the inside; if the door is
shut then the lock is locked and secure.
• To temporarily unlock the door from the outside, enter
a User Code. There is no way to leave the lock
permanently unlocked.
• The lock is always unlocked from the inside. To open the
door from the inside, simply turn the lever and exit.
Temporary Unlocking Using the Keypad
1. Enter a User Code into the
keypad. The lock comes
with two factory preset User
Codes. See the Keypad Locks
Programming Guide.
4
2. Watch the Schlage button. If it
lights green, a valid code was
entered and the lock is temporarily
unlocked. If it lights red, then an
invalid code was entered.
Find the yellow Programming Sticker on the
Keypad Locks Programming Guide
Programming Code XXXXXX
User Code A xxxx
User Code B xxxx
»
It is recommended that you change your User
Codes on a periodic basis so buttons wear evenly.
»
If lighting is low, press the Schlage button to
illuminate the keypad before beginning.
»
To program User Codes and the Programming
Code, see the Keypad Locks Programming Guide.
3. Rotate the lever to open the
door. Door will automatically re-
lock after a few seconds..
S/N x-xxxxxxxx
Model xxxxx