Powering On The Alarm; Powering Off The Alarm; Programming The Alert Setting; Sensitivity Level - Schlage FE575 Guide D'utilisation

Powering On the Alarm

1. Press the inside Schlage button for 5 seconds, until any light flashes around the Schlage button.
2. Release the inside Schlage button. The alarm is now turned on.
»
Not sure your alarm is activated? Simply press the Schlage button and it will
beep and light up to confirm it is activated. If it does not, confirm new batteries
are installed properly. See Replacing the Alarm Batteries on page 9.

Powering Off the Alarm

1. Press and hold the inside Schlage button until second LED flash.
2. Release the inside Schlage button. The alarm is now turned off.

Programming the Alert Setting

The alarm comes pre-set to the Forced Entry setting and is
ready to use. If you want to change it from Forced Entry to
another alert setting, follow these simple steps:
1. Press the inside Schlage button for 2 seconds, until it
flashes.
2. Release the button. The alarm will beep. Immediately
continue to press and release the inside Schlage button
to cycle through the three alert settings. Stop pressing
the button when the setting light that matches your
desired alert setting is lit.

Sensitivity Level

The sensitivity level indicates the level of touch or activity needed to set off the alarm.
There are five levels of sensitivity, with one (1) being the most sensitive and five (5)
being the least sensitive. The lock comes pre-set to level 3.
1. Press and hold the Inside Schlage Button until the third LED flash. This will take
about 10 seconds.
2. Tab the Inside Schlage Button to cycle through the five sensitivity levels. Stop
tabbing to select the sensitivity level you prefer.
1
2
3
4
5
Sensitivity
LOW • • • • • • • • • • • • • • HIGH
»
If you want to check which alert setting the alarm
is currently activated to, press and release the Schlage
button once. The alarm will light up on the left, middle or
right of the LED track to indicate the alert setting.
Activity Alert Tamper Alert Forced Entry
Alert
»
As you cycle through the
five levels, the alarm will
beep the same number of
times as each setting level.
7