PHOTOCELL
CLEAN PHOTOCELL ANNUALLY OR AS NEEDED.
•
Remove upper shell.
•
Remove fan (See fan blades).
•
Remove photocell from its mounting bracket
•
Clean photocell lens with cotton swab.
TO REPLACE: Remove side cover near Operation switch.
•
Disconnect wires from Operation switch and remove photocell.
•
Disconnect wires from circuit board and remove side cover.
•
Install new photocell and attach wires to circuit board.
•
Replace switch wires to operation switch and side cover.
•
Replace fan and upper shell.
FUEL FILTER
CLEAN TWICE PER HEATING SEASON OR AS NEEDED.
FUEL FILTER A ON FUEL CAP
•
Remove fuel cap.
•
Take out fuel filter with clean kerosene.
•
Wash fuel filter with clean kerosene.
•
Replace fuel filter on fuel tank.
•
Replace fuel cap on fuel tank.
FUEL FILTER B ON FUEL LINE
•
Remove fuel line A from fuel pump by using wrench.
•
Take out fuel line from fuel tank by pulling out fuel filter
gasket.
•
Remove fuel filter assembly from fuel line
•
Wash fuel filter in clean kerosene.
•
Reassemble fuel filter in reverse order.
PUMP PRESSURE ADJUSTMENT
1. Remove right side panel. (If not using an accessory fuel pressure
gauge, please skip to #4)
2. Remove air vent screw.
3. Insert accessory fuel pressure gauge at outlet of air vent
screw.
4. Adjust pump pressure by turning pressure adjusting screw.
5. Turn pressure adjusting screw clockwise to increase pressure.
6. Turn pressure adjusting screw counterclockwise to decrease
pressure.
NOTE: Using heater without proper maintenance can lead to poor combus-
tion and soot production.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE CONNECTED TO A FUEL SOURCE.
16
MAINTENANCE
Fuel Line A
Fuel Line A
Gasket
Fuel Filter B
Pressure Adjusting Screw
Air Vent Screw
Kerosene Portable Heater Manual
Fuel Cap
Fuel Cap
Gasket
Fuel Filter A