Assembling Frame And Wheels - Mi-T-M MH-0400-0M10 Manuel D'utilisation

Note: Tools required: medium phillips screw driver, open end or adjustable wrench, long nose pliers.

ASSEMBLING FRAME AND WHEELS

1. Slide axle through wheel support frame. Install wheel bushings, flat washers (S) and wheel on axle.
NOTE: When installing wheels, tube valve should face out from support frame.
2. Place flat washers (L) and cotter pins on axle ends and bend cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers (L) and put wheel cap in flat washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Align the holes
on fuel tank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame
as shown in below and attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
DO NOT OPERATE HEATER WITHOUT SUPPORT FRAME FULLY ASSEMBLED TO TANK.
Fuel Tank Flange
Wheel Support Frame
Wheel (Semi-pneumatic)
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, CONNECTED TO A POWER SOURCE,
OR WHILE CONNECTED TO A FUEL SOURCE.
Kerosene Portable Heater Manual
Safety Guard
Nut
Flat Washer (L)
Cotter Pin
WheelCap
ASSEMBLY
Screw (L)
Air lnlet
Axle
Flat Washer (S)
Bushing
Cord wrap
Screw (S)
Wheel Tube Valve
11