Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING: NEVER SERVICE HEATER WHILE IT IS PLUGGED IN OR WHILE HOT!
NOTE: USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use of third party or other alternate components will void warranty
and may cause unsafe operating conditions.
FUEL TANK
•
Flush every 200 hours of operation or as needed (See Storage).
FAN BLADES
CLEAN EVERY SEASON OR AS NEEDED.
•
Remove upper shell (See air intake filter).
•
Use Allen wrench to loosen set screw which holds fan blade to motor shaft.
•
Slip fan blade off motor shaft.
•
Clean fan blade using soft cloth moistened with kerosene or solvent.
•
Dry fan blade thoroughly.
•
Reinstall fan blade to motor shaft.
•
Place fan hub flush with end of motor shaft.
•
Place set screw on flat end of shaft.
•
Tighten screw firmly (40-50 inch pounds/ 4.5-5.6 N-m). Reinstall upper shell
NOZZLE
Remove dirt in nozzle as needed.
•
Remove upper shell.
•
Remove fuel line B from burner assembly by using wrench.
•
Remove burner head from burner assembly.
•
Remove lead wire from spark plug.
•
Remove spark plug from burner head.
•
Carefully remove nozzle from burner head using socket wrench.
•
Blow compressed air through face of nozzle (This will remove any
dirt).
•
Inspect nozzle for damage. If damaged or clogged, replace nozzle.
•
Make sure plug is in place on burner head.
•
Reinstall nozzle into burner head and tighten firmly (175-200 inch-
pounds).
•
Reinstall spark plug in burner head.
•
Attach burner head to combustion chamber.
•
Attach spark plug wire to spark plug
•
Attach fuel line to burner head and tighten firmly.
•
Replace upper shell.
•
Attach ignitor wire to spark plug.
•
Attach fuel and air line hoses to burner head.
•
Reinstall fan blade and upper shell.
SPARK PLUG
CLEAN AND REGAP EVERY 600 HOURS OF OPERA-
TION OR REPLACE AS NEEDED.
•
Remove upper shell.
•
Remove spark plug wire from spark plug.
•
Remove spark plug from burner head using medium Phillips screw-
driver.
•
Clean and regap spark plug electrodes to 3.5 mm gap (+/- 0.5mm).
•
Reinstall spark plug into burner head.
•
Attach spark plug wire to spark plug.
•
Reinstall upper shell.
NEVER
LEAVE
CONNECTED TO A POWER SOURCE, OR WHILE CONNECTED
TO A FUEL SOURCE.
Kerosene Portable Heater Manual
MAINTENANCE
HEATER
UNATTENDED
Nozzle
WHILE
BURNING,
Nozzle
Photo Cell
Spark Plug
Spark Plug
Nozzle
15
Publicité
Chapitres
Table des Matières
Dépannage
