160992A3WF 08-18 GWS18V-45C.qxp_GWS 8/28/18 1:07 PM Page 15
WIRE BRUSH ASSEMBLY
Before assembling wire brush to this tool,
disconnect from the power source. Attach
hand guard (Fig. 1). Wire brushes are
equipped with their own threaded hub, simply
thread on to spindle. Be sure to seat against
shoulder before turning tool "ON".
TO REMOVE: Reverse procedure.
The user interface is used to preselect the speed and to indicate the status of the power tool.
SPEED PRESELECTION
You can use the button for speed preselection to preselect the required speed, even during
operation. The data in the following table are recommended values.
Material
Application
Metal
Brushing, rust re-
moval
Stainless
Grinding
steel
Metal
Rough grinding
Metal
Cutting
Masonry,
Cutting
stone
STATUS INDICATIONS
Battery status indicator (User interface)
green
yellow
red
Overload protection indicator
(User interface)
yellow
red
Power tool status indicator
(User interface)
green
yellow
Illuminated red
Flashing red
Flashing blue
Operating Instructions
User Interface (GWS18V-45PSC) (see figure 2)
Accessory
Cup brush
Fibre disc
Grinding disc
Cutting disc
Diamond cutting disc and cutting guide (cutting
stone is permitted only with a cutting guide)
Meaning/Cause
Battery charged
Battery almost empty
Battery pack empty
Meaning/Cause
Critical temperature has been
reached (motor, electronics,
battery)
Power tool is overheated and
switches off
Meaning/Cause
Status OK
Critical temperature has been
reached or battery is almost empty
Power tool is overheated or battery
is empty
Kickback shutdown, restart
protection has been triggered
Power tool is connected to a mobile
terminal device or settings are
being transferred
WIRE WHEEL ASSEMBLY
Before assembling wire wheel to this tool,
disconnect from the power source. Attach type
27 guard (Fig. 3). Wire wheels are equipped
with their own threaded hub, simply thread on
to spindle. Be sure to seat against shoulder
before turning tool "ON".
TO REMOVE: Reverse procedure.
Speed preselec-
tion level
1
2
3
3
3
Solution
Replace or charge battery soon
Replace or charge battery
Solution
Run the power tool at no load and allow it
to cool down
Allow the power tool to cool down
Solution
–
Run the power tool at no load and allow it
to cool down, or replace or charge the
battery soon
Allow the power tool to cool down, or re-
place or charge the battery
Switch the power tool off and on again
–
-15-
GWS18V-45PSC
-1
[min
]
4500
6000
9000
9000
9000