Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1609929T61.qxp_1974 8/18/16 1:32 PM Page 11
TYPE 27, 28 & 29 GRINDING
WHEEL ASSEMBLY
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
When using mounting wheels, thread
BACKING FLANGE all the way down onto
spindle, then place GRINDING WHEEL on
the spindle. Thread on the lock nut and
tighten nut using a lock nut wrench provided
with flange kit, while holding the spindle lock
in (Fig. 3).
TO REMOVE: Reverse procedure.
When using spin-on grinding wheels, thread
directly onto the spindle.
ABRASIVE TYPE 1A & 27A
WHEEL ASSEMBLY
Using the optional type 1A wheel guard, it is
possible to perform limited cutting on small
stock such as metal tubes, piping or rebar.
Do not attempt to cut large stock or sheets of
metal as this tool is not designed to be a
dedicated cutting tool.
Disconnect tool from power source. Be sure
that wheel guard is in place for cutting.
When using mounting wheels, thread
BACKING FLANGE all the way down onto
spindle, then place GRINDING WHEEL on
the spindle. Thread on the lock nut and
tighten nut using a lock nut wrench provided
with flange kit, while holding the spindle lock
in (Fig. 4).
TO REMOVE: Reverse procedure.
TYPE 1 ABRASIVE
STRAIGHT GRINDING WHEELS
designed for straight/die grinding. This tool
is not designed for use with type 1 abrasive
straight/die grinding wheels.
*Always follow manufacturer instructions*
Always use type 1A
protection guard for cutting.
Do not use type 1
abrasive
wheels
*AAA Rent-All 225-291-1356*
FIG. 3
SPINDLE
TYPE 27
SPIN-ON
GRINDING
WHEEL
FIG. 4
SPINDLE
BACKING
FLANGE
LOCK NUT
TYPE 1A
WHEEL
TYPE 27
WHEEL GUARD
BACKING
FLANGE
TYPE 27
GRINDING
WHEEL
LOCK NUT
TYPE 1A
WHEEL GUARD
TYPE 27A
WHEEL
11
Publicité
Table des Matières
