Height Adjustment Lever; Appliance Cord - sunjoe MJ506E Manuel De L'opérateur

Masquer les pouces Voir aussi pour MJ506E:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power off and unplug the lawn mower.
2. Pull the height adjustment lever out of the original slot
(Fig. 8).
Fig. 8
R
Height
adjustment slot
3. Insert the lever into the desired slot.
5-Position Height Adjustment:
(1) 1.0 in. (25 mm)
(2) 1.4 in. (35 mm)
(3) 1.8 in. (45 mm)
(4) 2.2 in. (55 mm)
(5) 2.6 in. (65 mm)
4. Reconnect the power supply to the lawn mower and
resume normal use.
Starting + Stopping
Do not switch on the lawn mower until it has been completely
assembled. Before switching on the unit, always check the
appliance cord and the extension cord for signs of damage.
Use only intact cords.
m
WARNING!
Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
m
WARNING!
Before switching on the lawn mower, make
sure that it is not in contact with any foreign objects. Keep
your hands and feet a safe distance away from the rotating
mower blades and the ejector opening. Failure to comply with
these warnings can result in severe personal injury.
IMPORTANT: Do not start the lawn mower in tall grass.
1. Place the unit on a level lawn surface.
2. Push a loop of the extension cord through the slot on the
extension cord restraint hook from the opposite side and
around the cord restraint hook. Insert the appliance cord
into the extension cord (Fig. 9).
Fig. 9
Appliance
cord
Height
adjustment
lever
NOTE: Do not plug the extension cord into the outlet until it
had been secured with the extension cord restraint holder and
connected to the lawn mower's appliance cord. Only use a
UL-rated extension cord for outdoor, all-weather use. Do not
use an extension cord over 100 ft (30 m). See Extension Cord
Chart on page 2.
3. Place the bulk of the extension cord on the lawn closest to
the starting point.
4. Before starting the lawn mower, hold the handle assembly
with both hands and tilt the handle downward to slightly
raise the front of the lawn mower. This will reduce the risk
of lawn damage during start-up (Fig. 10).
Fig. 10
5. To start the lawn mower, use one hand to press and hold
the safety lock button while the other hand squeeze one
of the switch levers. Once the machine powers on, release
the safety lock button and squeze the two siwtch levers
with both of hands (Fig. 11).
9
Extension cord
restraint hook
Slot
Extension
cord

Publicité

Table des Matières
loading

Table des Matières