Mowing Tips; Safety Lock Button - sunjoe MJ506E Manuel De L'opérateur

Safety lock button

Fig. 11
Switch bar levers
6. Let the motor get up to speed, gently lowering the lawn
mower down into the cutting position and start mowing
(Fig. 12).
Fig. 12
7. To stop the lawn mower, release the switch levers
(Fig. 11).

Mowing Tips

m
WARNING!
Inspect the area prior to mowing and
remove all the stones, sticks, wires, and other debris that
might be thrown by the rotating blades.
NOTE: Sharp blades will greatly enhance the performance of
the lawn mower, especially when cutting tall grass.
• Be sure to check the blades periodically for signs of wear
and replace them at least once per year, as described in
the maintenance section.
• In order to prevent electric shock, do not operate the lawn
mower in damp or wet conditions.
• Do not mow in a circle. Travel back and forth across the
lawn following the path outlined below (Fig. 13).
• When cutting thick grass, reduce your walking speed
in order to allow for a more effective cut and a proper
discharge of the clippings. For a healthy lawn, always cut
off one-third or less from the total length of the grass. The
average lawn should be approximately 1.5 to 2 in. (3.8 cm
to 5 cm) long during cool months, and more than 2 in.
(5 cm) long during hot months. If there is growth, the lawn
should be cut in the fall.
Fig. 13
• While mowing, make sure that the electric cable is always
behind you and resting on the area of grass already cut.
• The lawn will look better if it is always cut to the same
height and in alternate directions.
• When crossing any graveled area, release the switch
levers to turn off the lawn mower. The stones can be
picked up and thrown by the rotating blade.
• Set the lawn mower to the highest cutting height when
mowing on uneven ground or in tall weeds.
m
WARNING!
If you strike a foreign object, stop the motor
and disconnect the power cord. Thoroughly inspect the lawn
mower for any damage. Repair any damage before operating
the lawn mower.
Maintenance
m
WARNING!
Before cleaning, repairing, or inspecting
the lawn mower, disconnect the power supply to the unit and
verify that all moving parts have come to a complete stop.
General
• Always keep the lawn mower clean and free of grass, dirt,
or other debris.
• Keep the handles dry, clean, and free of oil and grease.
• After each cutting session, remove accumulated grass
clippings and debris using either a dry cloth or hand
brush. You may also clean the equipment with a damp
cloth. Do not use cleaning agents or harsh solvents as
they may damage the equipment's plastic components.
Make sure that no water penetrates the equipment's
interior as intake of water can destroy the switch/plug
mechanism and the electric motor.
10