Introduction - ABB EIB DELTA Meter plus Mode D'emploi

Introduction

The EIB Delta-Meters are PTB-approved, electronic, electricity meters
with an integrated ABB i-bus® EIB / KNX communication interface.
This manual describes meters for direct connection and meters with
external current and voltage transformers. The following pages describe
the installation of the Delta-Meters, the LC-Display and the parameters.
Figures explaining the parts of the meter are located on the last pages of
this manual.
Important notes
EIB Delta-Meters are intended solely for the measurement of electrical
energy. The installation and assembly may only be carried out by trained
electrical specialists. The appropriate norms, guidelines, regulations and
specifications should be observed when planning and setting up electrical
installations.
Advisory:
- Delta-Meters should be protected from damp, dirt and damage during
transport, storage and operation.
- Delta-Meters should not be operated outside the specified technical data.
- Sufficient cooling for the Delta-Meter must be allowed for.
Cleaning: If devices become dirty, they can be cleaned using a slightly
damp cloth and soap solution if a dry cloth does not remove the dirt.
Corrosive materials or solutions should never be used. Always disconnect
the meter prior to cleaning.
Maintenance: EIB Delta-Meters are maintenance-free.
No repairs should be carried out if damage occurs (e.g. during transport
or storage).
The warranty expires if the EIB Delta-Meter is opened.
42