Eib - ABB EIB DELTA Meter plus Mode D'emploi

EIB commissioning
The assignment of the physical addresses, group addresses and
parameter settings is carried out using the ETS program
(EIB Tool Software).
IMPORTANT:
Using the ETS2 V1.1 without the service release B results in a wrong
programming of this device.
Therefore the service release B or a higher ETS version (e.g. ETS2V1.3)
has to be installed on the PC prior to programming the device. Informa-
tion to the ETS is available on the internet www.eiba.com.
A detailed description of the available EIB application software and
parameter settings can be found in the "Product Manual
EIB Delta-Meter Plus".
The current transformer (ct) ratio and the voltage transformer (vt / ut) ratio
only influence the values shown on the LCD Display of the meter. All
values transmitted via EIB are secondary values without ct/vt ratio used.
53