Install The Hood - CIARRA CBCB4850-OW Manuel De L'utilisateur Et D'installation

Installation

Install the Hood:

1) If present, remove all protective poly film from the hood and/or parts.
2) Below is the hole drilling installation drawing:
EN
3) According to the 1:1 hole drawing, Drill 4*Ø8mm holes to accommodate
the hanging plate, tighten the bracket onto the ceiling with the expansion
bolt holes provided.
Attention: If the ceiling is made of wood, there is no need to drill holes,
and the hanging plate are directly fixed on the ceiling with 4pcs
6*40mm self-tapping screws.
Attention:
Observe the warning in the instruction sheet concerning the
operation of the appliance when air is discharged from the room.
When the range hood and appliance supplied with energy other than electricity
are simultaneously in operation, the negative pressure in the room must be not
exceed 4 Pa (4×10 Bar).
-5
8