Accessories - Proxxon LHW/E Mode D'emploi

Accessories

Accessories available from PROXXON
The following table shows you the recommended speed for different accessories, supplied for your LHW/E:
Carborundum grinding disc
Ideal for grinding, deburring, sharpening, rust removal and
roughing of steel and non-ferrous metal.
Silicon Carbide grinding disc
Ideal for grinding, deburring, sharpening, rust removal and
roughing of stone, glass, ceramics and other very hard
materials.
Flap Disc
The flap disc is made from aluminum-oxide with a high stock
removal rate and is ideal for grinding and smoothing of cast
iron, gray cast iron, stainless steel, steel, non-ferrous metal,
wood and plastic.
Corundum Bound Cut-Off Wheel
Ideal for cutting steel, non-ferrous metals, smaller plastic and
wooden bars.
Backing Disc
Hook and loop type, for use with sanding discs and sanding
fleece.
Corundum Sanding Discs
Velcro type, used on flat and convex surfaces.
Sanding Fleece
Velcro type, used for cleaning, matting and sanding of steel,
stainless, steel, non-ferrous metals. Also used for paint
removal.
Disc with tungsten carbide burrs
Carving wheel with needle-like tungsten carbide teeth. Ideal for
carving and sculpting, roughing and finishing in wood plastics
and fiberglass. Smooth cutting and excellent control. Do not
use on metal.
Do not use the cutting disc for roughening work. Risk
of fracture!
Storage and Handling of Accessories
• Always check mechanical condition of every
accessory before use!
• Never use damaged accessories!
• Always respect the maximum speed of the accessory.
• Always handle the accessories carefully! Careless
handling can cause injuries or damage accessory.
• Always keep the accessories dry while storage.
• Just keep accessories in a proper and clean
condition! It is necessary to change or clean
accessories if they are worn or dirty.
• Maintain storage order to avoid mistake of the
required accessory!
- 8 -
Warning!
Recommended:
28585 (60 grit 13.000 rpm
28587 (60grit): 10.000 rpm
28590 (100 grit): 2.000-15.000 rpm
28154: 10.000 rpm
28548 15.000 rpm
28549 (80 grit)
28550 (150 grit)
28554 (medium)
28555 (fine)
29050 15.000 rpm
Maximum:
20.000 rpm
20.000 rpm
20.000 rpm
20.000 rpm
20.000 rpm
20.000 rpm