Publicité
Les langues disponibles
Les langues disponibles
Bedinungsanl_UnitoolMulti_neu
11. Drillings for concealed hinges with a diameter of 26 mm
Generally the drilling jig is set to Tab distance of 4 mm and cannot be adjusted.
For this work step you need the following tools that are not included in this packing unit:
The 2 drill holes with ø 2 mm on the ring of the drill guide allow marking the required hole pattern
for screwing on the concealed hinges (fig.27).
11.1.
Slide the Hinge drill guide 26 mm into the jig body (fig.22).
11.2.
Continue with the next steps as described in points 10.2 to 10.5
*Alternatively to the HW multi-spur drill bit a WS forstner drill bit can be used. Please refer to
catalogue page for the Unitool Multi drilling jig.
2005-09-26 530 rL
23.05.2006
15:03 Uhr
Hinge drill guide 26 mm (Cat. No. 001.25.030)
HW multi-spur drill bit* ø 26 mm (Cat. No. 001.06.626)
HS twist drill bit ø 2 mm (Cat. No. 001.41.024) for marking the drilling
pattern
Depth gauge (Cat. No. 001.06.454)
Fig.27
- 7 -
- 14 -
Seite 14
Publicité
