Häfele Red Jig Mode D'emploi page 31

Bedinungsanl_UnitoolMulti_neu
5. Drillings for Minifix 12 connector with a drilling distance of 24 mm
For this work step you need the following tools that are not included in this packing unit:
5.1. Slide the Minifix drill guide 12/24 mm into the jig body (fig.14).
5.2. Secure the drill guide by screwing one of the vertical drill guides onto the jig body. Make
sure that you use a vertical drill guide that suits the wood thickness of the work piece
(fig.15).
5.3. Slide the jig onto the work piece as far as the edge of the work piece (fig.15).
5.4. Secure the jig by tightening the clamping screw that is attached to the jig body.
5.5. Now drill the vertical hole with the appropriately adjusted stop ring (fig.16).
5.6. Now drill the horizontal hole with the appropriately adjusted stop ring (fig.17).
6. Drillings for Minifix 12 connector with a drilling distance of 34 mm
For this work step you need the following tools that are not included in this packing unit:
6.1. Slide the Minifix drill guide 12/34 mm into the jig body (fig.14).
6.2. Continue with the next steps as described in points 5.2 to 5.6
2005-09-26 530 rL
23.05.2006 15:03 Uhr
Minifix drill guide 12/24 mm (Cat. No. 001.25.020)
HW multi-spur drill bit* ø 12 mm (Cat. No. 001.06.612)
HS twist drill bit ø 8 mm (Cat. No. 001.20.508)
Stop ring for multi-spur drill bit ø 12 mm * (Cat. No. 001.42.683)
Stop ring for twist drill bit ø 8 mm (Cat. No. 001.42.683)
Fig.14 Fig.15
Fig.16 Fig.17
Minifix drill guide 12/34 mm (Cat. No. 001.25.021)
HW multi-spur drill bit* ø 12 mm (Cat. No. 001.06.612)
HS twist drill bit ø 8 mm (Cat. No. 001.20.508)
Stop ring for multi-spur drill bit ø 12 mm * (Cat. No. 001.42.683)
Stop ring for twist drill bit ø 8 mm (Cat. No. 001.42.683)
- 4 -
- 11 -
Seite 11